![]() Control reversal is a phenomenon occurring only in wings with ailerons or other control surfaces, in which these control surfaces reverse their usual functionality (e.g., the rolling direction associated with a given aileron moment is reversed).ĭivergence occurs when a lifting surface deflects under aerodynamic load in a direction which further increases lift in a positive feedback loop. Divergence is a phenomenon in which the elastic twist of the wing suddenly becomes theoretically infinite, typically causing the wing to fail. In an aeroplane, two significant static aeroelastic effects may occur. In 1947, Arthur Roderick Collar defined aeroelasticity as "the study of the mutual interaction that takes place within the triangle of the inertial, elastic, and aerodynamic forces acting on structural members exposed to an airstream, and the influence of this study on design". ![]() After teaching the course for one term, Kármán passed it over to Ernest Edwin Sechler, who developed aeroelasticity in that course and in publication of textbooks on the subject. In the development of aeronautical engineering at Caltech, Theodore von Kármán started a course "Elasticity applied to Aeronautics". The term aeroelasticity itself was coined by Harold Roxbee Cox and Alfred Pugsley at the Royal Aircraft Establishment (RAE), Farnborough in the early 1930s. In 1926, Hans Reissner published a theory of wing divergence, leading to much further theoretical research on the subject. In addition, the National Physical Laboratory (NPL) was asked to investigate the phenomenon theoretically, which was subsequently carried out by Leonard Bairstow and Arthur Fage. One of his recommendations was that left and right elevators should be rigidly connected by a stiff shaft, which was to subsequently become a design requirement. Although the aircraft landed safely, in the subsequent investigation F. The first recorded and documented case of flutter in an aircraft was that which occurred to a Handley Page O/400 bomber during a flight in 1916, when it suffered a violent tail oscillation, which caused extreme distortion of the rear fuselage and the elevators to move asymmetrically. Problems with torsional divergence plagued aircraft in the First World War and were solved largely by trial-and-error and ad hoc stiffening of the wing. An early scientific work on the subject was George Bryan's Theory of the Stability of a Rigid Aeroplane published in 1906. The second failure of Samuel Langley's prototype plane on the Potomac was attributed to aeroelastic effects (specifically, torsional divergence). ![]() The synthesis of aeroelasticity with thermodynamics is known as aerothermoelasticity, and its synthesis with control theory is known as aeroservoelasticity. Flutter of control surfaces is usually eliminated by the careful placement of mass balances. flutter which is the uncontained vibration that can lead to the destruction of an aircraft.Īeroelasticity problems can be prevented by adjusting the mass, stiffness or aerodynamics of structures which can be determined and verified through the use of calculations, ground vibration tests and flight flutter trials.control reversal where control activation produces an opposite aerodynamic moment that reduces, or in extreme cases, reverses the control effectiveness and.divergence where the aerodynamic forces increase the angle of attack of a wing which further increases the force.Aircraft are designed to avoid the following aeroelastic problems: The study of aeroelasticity may be broadly classified into two fields: static aeroelasticity dealing with the static or steady state response of an elastic body to a fluid flow, and dynamic aeroelasticity dealing with the body's dynamic (typically vibrational) response.Īircraft are prone to aeroelastic effects because they need to be lightweight and withstand large aerodynamic loads. NASA testing a scale model Lockheed Electra in a wind tunnel for flutterĪeroelasticity is the branch of physics and engineering studying the interactions between the inertial, elastic, and aerodynamic forces occurring while an elastic body is exposed to a fluid flow.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |